 | The test 3 with the ADD 11/08 oil is still in progress. The same compressor and operating conditions was used, so we can compare the results with the previous test of the Soilcy oil. The measured data available and will be updated in the future. |
Test A3
Posted on March 24th, 2009 by David Krivánka
Component testing
Posted on March 18th, 2009 by David Krivánka
 | ATMOS Engineering is responsible for a study on the influence of the Soilcy oil. The collected data - database of the used materials and results of the tests are available. |
Test A2 evaluation
Posted on March 18th, 2009 by David Krivánka
| The test 2 with the standard mineral oil is completed. The same compressor and operating conditions was used, so we can compare the results with the previous test of the Soilcy oil. The measured data - Wearcheck oil analyses, pressure and temperature measurements are available. |
Test 1 evaluation
Posted on August 12th, 2008 by David Krivánka
| The test 1 "standard conditions testing" is completed. The measured data are being evaluated. The results - Wearcheck oil analyses, pressure and temperature measurements are available. |
Technical meeting in Eibar
Posted on August 12th, 2008 by David Krivánka
 | The technical meeting was held in Eibar at July 24th. You can find the documents from this meeting in the member area. |
Test 1: Standard conditions
Updated on June 30th, 2008 by David Krivánka
 | Here you can find the results of the "standard conditions testing". We use the same modified Albert E.95 compressor as described before. The page will be updated regularly. |
New oil arrived
Posted on April 8th, 2008 by David Krivánka
 | We have just recieved the new oil from Addinol. The tests will start at the end of this week. Thank you, Mr. Scholz! |
Soilcy compressor
Posted on March 26th, 2008 by David Krivánka
The modified Albert E.95 is ready for the tests. The compressor is equipped with 7 temperature and 5 pressure sensors. The temperatures and pressures are monitored 24 hours per day. The sampling period is 30 s during the standard operation and 1 s during the start or stop. The results are collected by an automated data acquisition controller which is directly accesible by network. We are testing the compressor with standard mineral oil right now.
Vibrations measurement
Posted on March 26th, 2008 by David Krivánka
We made preliminary vibration measurements of the screw block. Laser Doppler vibrometer PDV-100 was used for these tests. Results will be available soon.
Pre-test completed
Posted on March 26th, 2008 by David Krivánka
The pre-test was completed in the end of Frebruary. The oil samples were collected and sent to Wearcheck for analysis. Results are on the Wearcheck site.